Kenmore Oven F4/E1 error code
The control detected a shorted meat probe — the probe plugged into the oven jack is sending a faulty signal, or the jack itself is damaged. The oven shows F4/E1 because it cannot trust the probe reading for probe-based cooking.
Also shown as: F4 E1, F4-E1
Last updated: September 30, 2026
What causes the F4/E1 error?
- Damaged or shorted meat probe
- Worn or damaged probe jack in the oven wall
- Loose wire connection at the jack
How to fix Kenmore F4/E1 — step by step
Work through these in order, from simplest and safest first. Stop as soon as the code clears.
- Unplug and test the probe
Disconnect power, remove the probe, and measure its resistance with a meter — it should read about 59,000 ohms at room temperature. If it is far off, replace the probe. - Check the jack
Plug the probe in and confirm a firm fit. If the jack feels loose or looks damaged, it needs replacing. Also reseat any loose wire connections behind the jack.Safety warning: Always cut power at the breaker before working on the oven's wiring.
When to call a technician
- Probe and jack both test fine but the code returns
- The jack is damaged inside the oven wall
Frequently asked questions
Can I use the oven without the meat probe?
Yes — just unplug the probe and cook by time and temperature as usual. The F4/E1 code only affects probe-based cooking.
Sources
Every meaning and fix above was checked against official manufacturer documentation:
FixCode provides general troubleshooting information only — not professional repair advice. If you are unsure about any step, stop and call a qualified technician. Repairs done incorrectly can be dangerous and may void your warranty.