Maytag Dishwasher F9E1 error code
The dishwasher isn't draining fast enough — water is still sitting in the tub at the end of the cycle. The control flagged a long-drain fault, which is almost always a blockage somewhere in the drain path.
Also shown as: Long Drain
Last updated: September 30, 2026
What causes the F9E1 error?
- Clogged dishwasher filter
- Kinked, pinched, or clogged drain hose
- Garbage disposer knockout plug still in place (new installs)
- Clogged air gap or disposer
How to fix Maytag F9E1 — step by step
Work through these in order, from simplest and safest first. Stop as soon as the code clears.
- Clean the filter
Remove the filter from the tub floor and wash it thoroughly under running water to clear trapped food. - Check the drain hose
Follow the hose from the dishwasher to the sink and straighten any kinks; look for pinches or clogs. - Clear the disposer and air gap
If connected to a garbage disposer, run the disposer to clear it and confirm the knockout plug was removed on new installations. If you have an air gap, remove its cap and clear any blockage. - Power-cycle and retry
Disconnect power for 30 seconds to reset the control, then run a drain or short cycle.
When to call a technician
- Water still won't drain after cleaning the filter and hose
- Drain pump hums but doesn't move water
- Code returns immediately on every cycle
Frequently asked questions
Where is the dishwasher filter?
On most Maytag models it's a twist-out assembly on the floor of the tub under the lower rack — your owner's manual shows the exact spot.
Sources
Every meaning and fix above was checked against official manufacturer documentation:
FixCode provides general troubleshooting information only — not professional repair advice. If you are unsure about any step, stop and call a qualified technician. Repairs done incorrectly can be dangerous and may void your warranty.
Related error codes
All Dishwasher error codes across brands · All Maytag codes →