GE Dishwasher C2 error code
C2 appears when the total pump-out cycle stretched past seven minutes. Like C1, it means the dishwasher had a hard time draining, but the longer window suggests a more stubborn restriction. The control usually keeps beeping while this code is up.
Last updated: September 30, 2026
What causes the C2 error?
- Severely blocked air gap or drain hose
- Clogged garbage disposer
- Drain pump struggling against a restriction
How to fix GE C2 — step by step
Work through these in order, from simplest and safest first. Stop as soon as the code clears.
- Press RESET to stop the beeping
Press the RESET pad on the control panel to stop the beeping and cancel the current state. - Clear the drain path
Clean the air gap, check the drain hose for kinks or blockages, and run the garbage disposer to clear food waste, following the same steps as for a C1 drain issue.Safety warning: Turn off power at the circuit breaker before working under the sink.
When to call a technician
- C2 comes back after the drain path is fully clear
Frequently asked questions
How do I stop the beeping on a GE dishwasher C2 code?
Press the RESET pad to stop the beep, then work through the drain checks (air gap, hose, disposer) to fix the underlying drainage problem.
Sources
Every meaning and fix above was checked against official manufacturer documentation:
FixCode provides general troubleshooting information only — not professional repair advice. If you are unsure about any step, stop and call a qualified technician. Repairs done incorrectly can be dangerous and may void your warranty.